To install curtain on wrap around curtain rod, starting with place your two curtain panels in front of you, with the printed or colored sides facing down. Using a cloth marker, mark a 1-inch vertical line on the inside of the closing edges of each panel. Pins the panels along these lines then pulling up the edges for the two “good” parts meet. You have just created a 1-inch seam.
Insert the fuse hem into the seam as far as it will go. The pins will keep you from going more than 1 inch. Heat the iron and rest the seam on your ironing board. Apply heat to the seam. This will activate the adhesive and glue to two panels together. Allow the joint to cool before removing its pins. Now it has an extra long curtain panel. Pull your long curtain over your pre-installed wrap around curtain rod. Pull down on one side of the curtain until both sides fall in the same length on each side of the rod.
Take one end of the panel and pull it up and over the wrap around curtain rod. Take the section that is now covered over the center of the bar. Pull it down in a decorative way. Creating only once in the form of a half moon or “loot”. Pull on both ends of the panel until it covers evenly. Last, take one end of the panel and pull it up and over the rod holder and on the other side. Pull it through the loop you just created to tie it on the rod with a simple knot. Repeat the process with the other side to complete your treatment window wrapped in scarf.